Installation Manual

HE+ Series Infrared Gas Heater Installation and Operation Manual

FIGURE 14 REFLECTOR EXTENSIONS (OPTIONAL - IF REQUIRED )

Reflector extensions are 116” (295 cm) long and can be installed on one

side or both sides of the reflector

The three (3) holes in the reflector extension for “S” hooks are located

2.25” (5.7 cm) from each end and one at the center

1. Drill 3 x 1/4” (7 mm) holes in the center of the reflector trough to align

with the 3 holes in the top of the reflector extension

Reflector extensions

can be installed on

one or both sides

2. Insert “S” hook up through hole in the reflec-

tor extension trough

3. Rotate “S” hook approx. 90°, and insert lower

end of S hook up into hole in reflector exten-

sion

4. Continue to rotate “S” hook until reflector ex-

tension settles into place

11. REFLECTOR INSTALLATION

NOTE: Ensure that you are installing a single reflector - reflectors can ‘stick

together’ in packaging - take care to separate them individually.

After burner and tubes have been installed, slide the reflectors one at a time into the wire

hangers. As each successive reflector is installed on an in-line installation, the ends of the

reflectors will overlap by approximately 4 inches [100mm] to provide continuous coverage over

the entire tube system. Each alternate reflector overlap must be fastened together with a

minimum of two #8 x 1/2” sheet metal screws on each side of the reflector (field-supplied).

Note that for either horizontal or angle mounting of the reflector, the tube must be level along

its length. Improper mounting can result in overheating of controls and combustible materials.

Reflector extensions can be added to the heaters as an option. See Figure 14 below

Reflector Extension Kit 909000141

• Qty 1 x 10 ft long x 10 inch deep reflector

extension

• Qty 3 x “S” Hooks