Installation manual

Rinnai Australia 14 Sapphire Operation & Installation Manual
REMOTE / THERMOSTATIC CONTROLLED OPERATION
Additional information about Remote Thermostat Control Operation
Character Diagnostic Check. To check the display characters on the remote control turn the controller 'off' by
pressing the 'PWR' button then press P - T - T - OK in rapid succession.
The remote will then commence automatically cycling through all the display characters, finally displaying the full
screen as shown below.
This process takes approximately 20 seconds and does not affect any programming.
If any of the characters are not displayed contact your Rinnai stockist for a replacement controller.
The Fan and Snowflake symbols displayed are not utilized in the operation of the Sapphire heater.
A/M PWRTP
DOWN
UP
OK
A/M PWR
DOWN
UP
A/M PWRTP
DOWN
UP
OK
A/M
OK
TP
DOWN
UP
A/M PWRTP
DOWN
UP
OK
1
2
3
NOTE