Installation manual

Rinnai Australia 15 Sapphire Operation & Installation Manual

REMOTE / THERMOSTATIC CONTROLLED OPERATION

TO TURN YOUR HEATER ON WITH REMOTE / THERMOSTATIC CONTROL

MODES OF OPERATION

To Turn Remote ‘ON’ or ‘OFF’

Step 1. To turn ‘ON’ - press and release the ‘OK’ button and ‘PWR’ button at the same time. The

display will now include the setting temperature and the mode of operation.

Step 2. To turn ‘OFF’ - press the ‘PWR’

button only.

Manual Temperature Mode

• Temperature can be set at any level.

• Time and day of week does not need to be programmed to operate.

Step 1. With the controller turned ‘ON’, press and release the ‘A/M’ button until the word ‘MANUAL’

appears on the LCD.

Step 2. Press press the

‘UP’ button or ‘DOWN’ button to increase or decrease the temperature in

increments of 1°C.

BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.

Before remote / thermostatic control can be used the heater must be taken out

of the OFF/STANDBY condition (supply connected and switched ON but the

heater turned OFF), do this as follows:

Press ‘ON’/‘OFF’ button once the electronic ignition sparker will be able to

be heard.

Step 1. The electronic ignition stops when the pilot flame has been

established. The main burner then ignites off the pilot. Once the main

burner has ignited the heater can the be operated by remote /

thermostatic control.

NOTE

A/M PWRTP

DOWN

A/M TP

DOWN

A/M PWRTP

DOWN

A/M TP

DOWN

11 12 12

STEP 1 STEP 2

A/M PWRTP

DOWN

PWR

DOWN

STEP 1 STEP 2

A/M PWRTP

DOWN

A/M PWR