Installation manual

Rinnai Australia 7 Slimfire 252 Operation & Installation Manual
OPERATION
TO TURN YOUR HEATER ON
ADJUSTING HEAT
The Slimfire has three heating settings LOW , MEDIUM and HIGH .
Press each of the control buttons in order from right to left, this will ignite additional burners and modulate the fan
speed as shown in diagram below.
FAN OPERATION
The fan will operate automatically when the heater warms up, and will stop when the combustion chamber cools.
When the heater is on the ‘high’ setting the fan will operate on high speed when the heater is hot.
When the heater is on the’ low’ or ‘medium’ heat setting, the fan will operate on slow speed when the heater is hot.
When the heater is on its lowest setting the fan may turn off as the heater cools and restart when warm again.
The fan may continue to operate on slow speed when the burners have been extinguished until the heater cools
down.
TO TURN YOUR HEATER OFF
To turn the heater ‘OFF’ push and release any of the operated control buttons from left to
right in sequence until all are released.
POWER OUTAGES
BEFORE PROCEEDING ENSURE THE GAS AND ELECTRICITY ARE TURNED ON.
You must read and understand these instructions fully before operating the heater.
The push button controls are located on the front lower left hand side of the heater.
Step 1. Press the right hand control (Ignition/Low) button firmly. This
operates the built-in safety device and starts the electronic spark. The
front burner and pilot will ignite. Check that the burner has lit and
continue to hold the button down for up to 15 seconds. The spark will
continue while the button is held down.
Step 2. If the burner does not remain alight, Push the Ignition/Low
button again and release it. This will return it to the ‘OFF’
position. Wait 30 seconds, then repeat the ignition procedure.
The Ignition/Low button
MUST BE in the ‘OFF’ position
before attempting re-ignition.
There is no need to hold the buttons for 15 seconds when adjusting the heat.
The relationship between the burner operation and the fan speed are preset and can not
be independently adjusted.
BUTTON
INGITION/LOW MEDIUM HIGH
FAN SPEED LOW LOW HIGH
FRONT BURNER HIGH HIGH HIGH
REAR BUNER OFF LOW HIGH
MJ/h Usage
Natural Propane Natural Propane Natural Propane
7.7 9.0 14.2 15.8 25.0 25.0
If there is a power failure when the heater is in operation the overheat protection may shut off the
gas to protect the heater. In the event of a power failure, turning the heater to its lowest setting may
allow the heater to continue operating without overheating. The fan will not work without electrical
power.
NOTE
a
HIGH MED
IGN
~
LOW
a
c
b
a
NOTE
a
a
b
c
NOTE
a
a
b
c
bc a
NOTE