Installation manual

Rinnai Australia 23 Slimfire 252 Operation & Installation Manual
COMPLETING HEATER INSTALLATION
PREPARING FOR COMMISSIONING
Step 1. Removing the Burner Box Glass
Loosen but do not remove the two retaining screws for the bottom burner box glass clamp . While supporting
the burner box glass panel in place, completely unscrew and remove the two retaining screws and the top
burner box glass clamp . Then lift burner box glass panel away and place it safely aside where it can not get
damaged.
Step 2. Unpacking the Log Set & Granules Satchel
Unpack the log set and the burner granules . These are attached to the outside top of the heater engine.
Carefully unpack the logset from the packaging material and inspect for damage. If ANY damage is evident
DO NOT continue with installation and contact your supplier for advice.
The satchel containing the burner granules is taped to the outside of the foam packing that
contains the log set. Ensure that you locate and remove the satchel before discarding the
packaging material.
H
D
A
B
G
E
C
F
D
B
A
A
ENSURE TO LOOSEN BOTH
THE LEFT AND RIGHT
RETAINING SCREWS .. ..
A
A
B
D
E
C
G
H
IMPORTANT
H
G
F