Installation manual

Rinnai Australia - i - HOTFLO Electric Storage Water Heater Operating/Installation Manual
Your Rinnai Hotflo Mains Pressure Vitreous Enamel Electric Storage Water Heater has been certified by relevant
plumbing and electrical authorities and the details are shown on data plate.
This appliance must be installed correctly by an authorised person and must conform to location regulations.
The installation must also comply with the instructions supplied by Rinnai.
Please keep this instruction booklet in a safe place for future reference.
Notice to Victorian Consumers
This appliance must be installed by a person licensed with the Plumbing Industry Commission.
Only a licensed person will have insurance protecting their workmanship.
So make sure you use a licensed person to install this appliance and ask for your Compliance Certificate.
For further information contact the Plumbing Industry Commission on 1800 015 129.
Installation and service only by an authorised person.
Removal of access covers will expose 240V wiring. Access covers to be removed by authorised persons only.
This water heater is not intended to be operated or adjusted by young children or infirm persons. Young children
must be supervised to ensure they do not interfere with the water heater.
If the power supply cord, plug or electrical conduit to the water heater is damaged, it must be replaced by an
authorised person in order to avoid a hazard, using genuine replacement parts available from Rinnai.
• DO NOT operate this system before reading the manufacturers instructions
• DO NOT place articles on or against this appliance
• DO NOT store chemicals or flammable materials near this appliance
• DO NOT operate with panels or covers removed from this appliance
• DO NOT activate heating elements unless cylinder is full of water
• DO NOT touch any power supply cords, plugs or electrical conduits with wet hands.
REGULATORY INFORMATION
WARNINGS