System Design Drawings

domestic temperature.
Note:
1. Ensure TMV1 check valves are
removed. (This will be diverter valve.)
2. Set TMV1 20F below Rinnai
temperature setting.
3. TMV2 should be set to desired
Applies to HE, HE+. SE. and Sensei Models
Collector Sensor
T
hermostatic
Solar Controller
Rinnai Tankless
Condensate Drain Line As
Cold Water Supply
Hot Water
Gas Supply
Supply
Mixing Valve 2
Solar Backup Option 2
Appropriate
Mixing Valve 1
Thermostatic
Tank Sensor
Solar Storage Tank
AB
12.15.2018RS
11.16.2018
This is not an engineering drawing; it is intended only as a guide and not
as a replacement for professional engineering project drawings. This
drawing is not intended to describe a complete system. It is up to the
contractor or engineer to determine the necessary components and
configuration of the particular system to be installed. The drawing does
not imply compliance with local building code requirements. It is the
responsibility of the engineer or contractor to ensure that the installation is
in accordance with all local building codes. Confer with local building
officials before installation.
1-800-621-9419
PROHIBITED.
Systems Design Manual
SHEET 1 OF 1
D
C
B
A
A
B
C
D
1
2
3
4
5
6
7
8
8
7
6 5
4
MACHINED X.XXX =
12.15.2018
WH1-S-2
UNLESS OTHERWISE SPECIFIED:
RINNAI AMERICA CORPORATION
REV
PEACHTREE CITY, GA 30269
0.005
SCALE: NTS
DO NOT SCALE DRAWING
WEIGHT:
Angle =
THIRD ANGLE PROJECTION
2
DWG. NO.
SH
B
3
INTERPRET GEOMETRIC
1
103 INTERNATIONAL DRIVE
0.010
TOLERANCING PER:
MATERIAL
FINISH
DRAWN
CHECKED
ENG APPR.
COMMENTS:
DATENAME
TITLE:
SIZE
TOLERANCES:
Sheet Metal X.XX = 0.030
X.XXX = 0.010
Fraction = 1/32
Angle = 1.0
THE INFORMATION CONTAINED IN
THIS DRAWING IS THE SOLE
PROPERTY OF RINNAI AMERICA. ANY
REPRODUCTIONIN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF RINNAI AMERICA IS
PROPRIETARY AND CONFIDENTIAL