System Design Drawings

AB
12.15.2018RS
11.16.2018
This is not an engineering drawing; it is intended only as a guide and not
as a replacement for professional engineering project drawings. This
drawing is not intended to describe a complete system. It is up to the
contractor or engineer to determine the necessary components and
configuration of the particular system to be installed. The drawing does
not imply compliance with local building code requirements. It is the
responsibility of the engineer or contractor to ensure that the installation is
in accordance with all local building codes. Confer with local building
officials before installation.
PROHIBITED.
SHEET 1 OF 1
D
C
B
A
A
B
C
D
1
2
3
4
5
6
7
8
8
7
6 5
4
3
2
MACHINED X.XXX =
Systems Design Manual
RINNAI AMERICA CORPORATION
PEACHTREE CITY, GA 30269
SH
0.005
DO NOT SCALE DRAWING
12.15.2018
INTERPRET GEOMETRIC
UNLESS OTHERWISE SPECIFIED:
Angle =
REV
1-800-621-9419
SCALE: NTS WEIGHT:
WH1-SH
THIRD ANGLE PROJECTION
1
103 INTERNATIONAL DRIVE
0.010
TOLERANCING PER:
MATERIAL
FINISH
DRAWN
CHECKED
ENG APPR.
COMMENTS:
DATENAME
TITLE:
SIZE
B
DWG. NO.
TOLERANCES:
Sheet Metal X.XX = 0.030
X.XXX = 0.010
Fraction = 1/32
Angle = 1.0
THE INFORMATION CONTAINED IN
THIS DRAWING IS THE SOLE
PROPERTY OF RINNAI AMERICA. ANY
REPRODUCTIONIN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF RINNAI AMERICA IS
PROPRIETARY AND CONFIDENTIAL
or stainless construction.
Primary Pump
Pump must be sized for the flow rate of the heating
system. Pump must also be sized to overcome
pressure loss through the system at the desired flow
rate. Refer to the Operation and Installation Manual
for the model's pressure loss curve. To be of bronze
Applies to HE, HE+, SE, and Sensei Models
Space Heating Zone
P
ressure Reducing
Primary
Valve (as required)
Supply
Condensate Drain Line As Appropriate
Gas Supply
Cold Water Supply
Hot Water
Pump
Building Outlets
Rinnai Tankless
Hydronic Heating