Installation manual
Rinnai CVent 20
Installaon Instrucons
Back to back Conguraon (2 to 8 water heaters)
In Line Conguraon (2 to 8 water heaters)
Refer to the Ubbink appendix of this manual for the vent system assembly instrucons.
Follow these Rinnai installaon instrucons in this manual in addion to the Ubbink vent system assembly
instrucons.
Install the venng according to one of the 2 conguraons below. Do not locate the common vent remotely
from the water heaters.
The installaon area should be measured to make sure that adequate space is available to install the water
heaters and venng system.
NOTE: Dimensions above
are used in all back to back
configurations
Note: If water heaters are mounted directly on a wall, air intake piping will need to be in front of the appliance
adapters. The intake header in the drawing above has been removed for illustraon purposes.
TYPICAL
20.5” (520)
3°
1”
(25mm)
2”
(51mm)
3”
(76mm)
EXHAUST
AIR
INTAKE
7”
(178mm)
6.25”
(159mm)
1”
(25mm)
2”
(51mm)
3”
(76mm)
3°
4”
(101mm)
5”
(127mm)
6”
(152mm)
7”
(178mm)
TYPICAL
20.5” (520)
AIR
INTAKE
EXHAUST