Installation Guide

ManualsBrandsRinnai ManualsAppliance AccessoriesSmartbox Recess Box

Rinnai 1 Smartbox SBOXI/SBOXC/SBOXF

Take care to AVOID exposing Smartbox

components to ANY EXCESSIVE HEAT when

welding pipes.

The Smartbox® recess enclosure system is

made up of two (2) components these are the

SBOXI (insert) and SBOXC (cover). Both items

are packaged and purchased separately.

If you DO NOT have a SBOXC (cover) for your

Smatbox contact your supplier.

RA TSD 04-114 Issue 2 29/01/2010

SBOXC

SBOXI

Cover

Clip

Slot

Cover

Clip

Slot

Cover

Clip

Slot

Cover

Clip

Slot

Pipe

Access

Slot

Support

Bracket

Slot

REFER TO THE FOLLOWING INSTALLATION INSTRUCTIONS FOR FULL INSTALLATION DETAILS

DO NOT

Obstruct the slots provided for the Cover Clips, Support Bracket or Pipe Access

Securing the Smartbox

Insert externally

Securing the Smart

Box Insert internally

through the side wall

Securing the Smart

Box Insert internally

through the rear wall

Securing the Smart

Box Insert with the use

of brick ties

Securing Method

Summary of content (4 pages)

PAGE 1
The Smartbox® recess enclosure system is made up of two (2) components these are the SBOXI (insert) and SBOXC (cover). Both items are packaged and purchased separately. SBOXC SBOXI Take care to AVOID exposing Smartbox components to ANY EXCESSIVE HEAT when welding pipes. If you DO NOT have a SBOXC (cover) for your Smatbox contact your supplier.
PAGE 2
Smartbox® RECESS ENCLOSURE COMPONENTS SBOXI (insert) and SBOXC (cover) packaged and purchased separately. GENERAL PREPERATION 1. Prepare an opening in the wall approximately 1 metre above the ground. The opening requirements are Height 1030mm, Width 390mm and a minimum Depth of 160mm (see dimension diagrams page 2). Ensure the location complies with the requirements of AS 5601 Fig. 5.3. 2. Remove the transport tab 1 from the pipe entry point of the insert. 3.
PAGE 3
IMPORTANT The Rinnai water heater serial and model numbers on the data plate located on the left hand side of the appliance MUST BE copied to the sticker on the inside of the Smartbox cover. The serial and model numbers are required for future service work. 5. Remove the two M5 Nyloc nuts 3 from the fixing studs 4 of the insert. 6. Insert the upper mounting bracket 5 of the Rinnai water heater into the bracket slot 6 located at the top of the insert. 7.
PAGE 4
Smartbox® SEMI-RECESS FRAME USE The SBOXF (Frame) is used when a semi-recessed installation of the Smartbox recess enclosure is required. SBOXF reduces the cavity depth requirements of the SBOXI (Insert) by 60mm. This is useful where the depth of a wall cavity is insufficient to allow SBOXI to be fully recessed (for example weatherboard or other non masonry walls).