Operating instructions

Rinnai New Zealand Limited RDV3610 Operation Manual: 11620-D
04-10
15
Programming your controller
Settingtheclock
The clock must be set before the programmed timers will operate.
1. With the controller (heater) off, press ‘T’ for two seconds.
2. Using the ‘UP’ and ‘DOWN’ buttons, adjust the hours to the correct
time. Ensure you have the correct time of the day (AM/PM). Press ‘OK’
to accept.
3. Repeat process to adjust the minutes and day of the week.
A/M PWRT P
DOWN
UP
OK
Each day of the week can be programmed for four periods, making a total of 28 programmed
periods. Week settings available:
MO  TU  WE  TH  FR  MO TU WE TH FR  SA  SU  SA SU  MO TU WE TH FR SA SU
A weekday program can be set so the program is used Monday to Friday. Similarly, a weekend
program can be set for Saturday to Sunday.
Factorydefault
settings
(Mon-Sun)
If you do nothing to change the programming the default settings (shown
below) would be available if you set it to automatic mode. When in this
setting, the heater will automatically turn itself on and off depending on
the temperatures set (similar to an air conditioning unit).
For example:
If the room temperature at 1am falls below 15 °C, the heater will turn on
and stay on until the room temperature increases above 15 °C.
TimePeriod StartTime Temperature°C
Period 1 6.00 am 20 °C
Period 2 8.30 am 15 °C
Period 3 5.00 pm 21 °C
Period 4 10.30 pm 15 °C
If you would like to stop the heater from coming on at all, for example,
during the night and before period 1, you can reduce the temperature
setting using the DOWN button until –– °C is reached. This means no set
temperature has been programmed, and your heater will stay off until the
next period setting.
For example:
TimePeriod StartTime Temperature°C
Period 1 5.30 am 20 °C
Period 2 8.00 am 15 °C
Period 3 5.30 pm 20 °C
Period 4 11.30 pm
–– °C
To revert back to the default settings, press the following sequence of
buttons, P > T > T > DOWN.