Installation manual

Rinnai Australia 28 Installation Manual

HEATER LOCATION

ENCLOSURE REQUIREMENTS

Consult a qualified electrician if direct wiring is required as it must comply with the

requirements of AS/NZS 5601 & AS 3000 and any other relevant local regulations.

The electrical cord must not come into direct contact with the heated parts of the appliance

or flue system.

If the power cord is damaged and requires replacing, it must be replaced by a licensed

tradesperson. It must be a genuine replacement part available from Rinnai.

RDV3610ETR

The appliance must be positioned on a flat level surface. As this

appliance has a cool outer casing it can be installed into a

decorative fireplace constructed from materials such as wood or

plaster. The only exception is the cladding above the appliance

which must be non-combustible and extend at least 400 mm above

the appliance in accordance with the drawings on page 4, page 27

and page 39.

If the appliance is elevated from the ground, a base must be

constructed using suitable material with supporting joists, capable

of easily supporting a minimum of 175kg. (Flue must be supported

independently of the appliance).

RDV3611ETR

Cladding material need not be non-combustible. Ensure

construction is in accordance with drawings on page 4, page 27

and page 39.

ENCLOSURE DIMENSIONS

Enclosure dimensions as shown. The enclosure dimensions

specified are critical to the successful installation of this appliance

and must be strictly adhered to.

IMPORTANT

850 min

Typical Frame Layout

5mm

1830 mm

Corner Installation Layout