Installation manual

Rinnai Australia 5 Operation & Installation Manual
SAFETY
Unpack the heater and check for damage. DO NOT INSTALL DAMAGED HEATER. If the heater is damaged,
contact your supplier for advice. Before installing the heater, check the label for the correct gas type (refer rating
plate, inside the appliance).
Remove shipping clamps on bottom edge of appliance before attempting to lift heater.
Refer to local gas authority for confirmation of the gas type if you are in doubt.
• If the supply cord is damaged or requires replacing, it must be replaced by the manufacturer or
the manufacturer's agent or similarly qualified person in order to avoid a hazard.
• Heater must not be located immediately below a power socket outlet.
• DO NOT connect to an LPG Gas cylinder indoors.
• A dedicated 240 V earthed 10 Amp power point must be used with this appliance.
• The appliance is not intended for use by young children or infirm persons without supervision.
• DO NOT modify this appliance. Modifying from original specifications may create a dangerous
situation and will void your warranty.
• Only the flue components specified by Rinnai must be used.
WARNING