Installation Manual

30 Rinnai Tankless Rack System (TRS) Installation Manual
Installation
6
Hoisng Liing Lugs
Lugs are installed on the top side of the following
racks for hoisng and moving. The lines or cables to
the lugs should be at a 90° angle. Use a spreader
liing bar to hoist the racks.
Weights of the complete assemblies are available in
the Specicaons secon of this manual.
DO NOT hoist the crate or palee.
Spreader Liing Bar
TRS02CU TRS02ILCU TRS03
TRS03ILCU TRS04CU TRS05CU
TRS06CU
TRS046CU
TRS023ILWCU
TRS036CU TRS023ILCU
90°
When selecng an installaon locaon, you must ensure the tankless water heaters mounted on the rack comply with
the required clearances. For clearance requirements, refer to the “Rinnai Tankless Water Heater Installaon and
Operaon Manual” supplied with each water heater in the rack system.
Clearances
Li the Rack
Models Available with Liing Lugs