Installation Manual

Rinnai Tankless Rack System (TRS) Installation Manual 55
Installation Checklist
13
Complete the following checklist when installaon is complete. You should be able to answer YES to each queson. If
you answer NO to any queson, installaon is not complete. Refer to the applicable secon in the “Rinnai Tankless
Water Heater Installaon and Operaon Manual” for addional informaon.
Reference the “Rinnai Tankless Water Heater Installaon and Operaon Manual” For
Addional Informaon on the Items Below
INSTALLATION LOCATION YES NO
Have you veried the units, vents and air intakes meet the clearance requirements?
 
COMBUSTION AIR & VENTING YES NO
Have all corrosive compounds been removed from around the combuson air inlet of the tankless water
heaters?
 
Have you followed the combuson air requirements to provide sucient combuson air for the tankless
water heaters?
 
Are the correct venng products for the installed models being ulized?
 
Have you installed the vent screen(s) for PVC vent applicaons?
 
Have you veried the vent systems do not exceed maximum length?
 
PLUMBING YES NO
Have you ensured that a pressure relief valve is installed with a rang that exceeds the BTU input of the
water heater models? Refer to the rang plate on the side of each water heater for BTU input.
 
Have the water lines been purged of all debris and the lter cleaned? Debris will damage the water heaters.
Clean the inlet water lter by closing the cold and hot water inlet isolaon (shut-o) valves. Put a bucket
under the lter at the boom of each water heater to catch any water that is contained inside the unit.
Unscrew the water lter. Rinse the lter to remove any debris. Install the lter and open the isolaon
valves.
 
Have you veried the hot and cold water manifolds to each tankless water heater are not interchanged?
 
Does the water supply to the heaters have adequate pressure? Minimum water pressure is 50 psi. Rinnai
recommends 60-80 psi for maximum performance. Is the water supply free of chemicals? Did you verify the
water supply does not exceed total hardness that will damage the heat exchangers?
 
Have you veried that toxic chemicals were not introduced to the potable water?
 
Did you drain the tankless water heaters if not intended to be used immediately?
 
Have water quality issues (if any) been addressed?
 
Have you performed the leak and pressure test for the tankless water heaters and plumbing system?
 
Connued on next page