Replacement Part List

IMPORTANT
Please read these instructions carefully
before you start to assemble this product .
Please carry out the steps in the order set
out in these instructions.
Keep these instructions in a safe place for
future reference.
Safety Advice
For safety purposes we strongly
recommend the product to be assembled by at least two people.
Some parts may have sharp edges.
Please be careful when handling components. Always wear
gloves, eye protection, and long
sleeves when assembling or performing any maintenance on your
product.
Do not attempt to assemble the
product in windy or wet conditions.
Do not attempt to assemble the
product if you are tired, have taken drugs,
medications or alcohol, or if you are
prone to dizzy spells.
Dispose of all plastic bags safely -
keep them away from children's reach.
Keep children away from the
assembly area.
When using a stepladder or power
tools, make sure that you are following
the manufacturer's safety advice.
Keep roof and gutters clear of snow,
dirt & leaves.
Heavy snow load on the roof can
make it unsafe to stand below or nearby.
Do not lean against or push the
product during construction.
Hot items such as recently used grills,
blowtorches etc. must not be stored inside the product.
Heavy or sharp articles should not be
leaned against the wall panels.
Make Sure there are no hidden pipes
or cables in the ground before inserting the pegs (not supplied)
Do not touch overhead power cables
with the aluminum profiles.
If color was scratched during
assembly it can be fixed.
Note: This product must be
anchored on to a leveled surface and solid foundation to ensure its
stability.
Make sure that screws and anchors
are compatible with foundation type. Make sure that there are no
obstructions between the assembly
area and the final position.
Cleaning Instructions
In order to clean the product, use a
mild detergent solution and rinse with cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean the panels.
Clean the product once assembly is
complete.
Before Assembly
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled
and have a solid base such as
concrete, asphalt, deck etc.
Parts should be laid out close at hand. Keep all small
parts (screws etc.) in a bowl so they
do not get lost.
Please consult your local authorities if any permits are
required prior to constructing the
product.
Make sure you received all boxes according to the
additional page (Extending your
SunRoom) on the instruction manual.
As soon as you are ready to assemble your product
(you can start with this
box), sort the parts and check against the content
parts list.
Complete site preparation before unpacking parts
and beginning assembly.
The drawings in this manual are designed for 8' x 8' &
8' x 10' product.
Tools & Equipment
GT1 - Special tool to connect pins
through lined up holes.
Pin Tool fixs and locks profiles in place.