Instruction manual

100
Memory Functions
6. Use the INC and DEC keys to select the processing start address. (The left border of
the screen corresponds to the processing start address.)
7. Use the and keys to select the processing end address.
8. The bottom of the screen shows "P_AVE . dB" (when power sum is selected:
"P_SUM . dB").
The result for power average or power sum processing (for all frequency bands
together) is shown on the graphical screen or the numeric list display.
When reverberation processing is selected, the display shows "REVERB . S".
In this mode, the analysis data in the graphical screen and numeric list display are
recalled data from the start address of the processing range. (The same applies when
recall processing is set to OFF.)
9. When the recall screen is terminated, processing is automatically set to OFF.
If the start address (START ADDR) and end address (END ADDR) were specified
in step 4 on the MEMORY menu screen, the cursor automatically is placed on the
processing end address during level-time recall display.