Instruction manual

39
Setting Measurement Parameters
MEMORY menu screen
MEMORY BLOCK: AUTO1 AUTO2 MANU
Selects the memory block for storing or recalling data.
BLOCK CLEAR: OFF EXEC
Serves to erase stored data.
AUTO STORE TYPE: SINGLE GROUP
Determines whether auto store data are composed of a single
processing function or of all processing functions.
PERIOD: 1 to 10 ms, 10 to 990 ms
Determines the store interval for auto store. Can be set from 1
to 10 milliseconds in 1 ms steps and from 10 to 990 millisec-
onds in 10 ms steps.
NUM: FREE 100 to
Sets the memory address number up to which storing is pos-
sible.
FREE: Memory upper limit is set as described on page 76.
100 to : Memory number is changed in steps of 100 with the
INC or DEC key.
PROTECT
AUTO1: OFF ON
AUTO2: OFF ON
MANU: OFF ON
When set to ON, the respective memory area is protected from
being overwritten. This serves to preserve measurement data.
When PROTECT is active, BLOCK CLEAR also has no ef-
fect.
RECALL CALC: OFF P_AVE P_SUM REVERB
Selects the type of calculation to be used for the recall mode.
The start address and end address are specified using START
ADDR and END ADDR.
P_AVE: Power average is calculated and displayed.
P_SUM: Power sum is calculated and displayed.
REVERB: Reverb time is displayed.
START ADDR: 00001 to Analysis start address
END ADDR: 00001 to Analysis end address
To set the START ADDR and END ADDR, use the and keys to move the
underline and then use the INC and DEC keys to set the value.