Instruction manual

41
Setting Measurement Parameters
I/O menu screen
PRINT MODE: SINGLE SUCCESSIVE
Determines whether the printer (DPU-414, CP-10, CP-11)
prints only one sheet or operates continuously. The "SUCCES-
SIVE" setting is valid only in recall mode.
SUC. PRINT BLK: AUTO1 AUTO2 MANU
Specifies the memory block for successive printing.
START: 00001 to
END: 00001 to
Specifies the start address and end address of the memory
block specified for printing.
INTERFACE PORT: SERIAL OPTICAL
Selects either the serial port or the infrared optical port for I/O
communication.
BAUD RATE
SERIAL: 4800 9600 19200 38400
OPTICAL: 57600 115200
PRINTER: 4800 9600
Sets the baud rate for the respective interface.
BEEP: OFF ON
Determines whether a beep tone is produced at the end of mea-
surement and at other times.
REMOTE CONTROL: OFF ON
When wishing to use the supplied remote control (NA-27RC1),
this item must be set to "ON".
DC OUT: MAIN SUB
Specifies which channel signal is supplied at the DC OUT out-
put on the side of the unit.
DATE: / /
TIME: :
These items allow the user to specify the date and time. While
the menu is displayed, the time indication does not advance.
VERSION: .