Instruction manual

66
Data Exclusion (Back-Erase) Function
When a measurement is being carried out and data are being processed, the PAUSE/
CONT key can be used to suspend the measurement. Normally, data up to the point at
which the PAUSE/CONT key was pressed will be included in processing, but the data
exclusion function makes it possible to exclude (back erase) data from an interval of 1 to
5 seconds before the key was pressed.
To activate the back-erase function, carry out the following steps.
1. Press the SETUP key to call up the SETUP menu screen.
(For an explanation of how to use the SETUP menu screen, refer to page 30.)
2. Set the "BACK ERASE TIME" item to the desired value. The setting range is 0 to
5 seconds in 1 second steps.
3. Press the SETUP key once more to return to the original measurement screen.
Important
- The back-erase function is not available in statistical
modes and in Ltm3 or Ltm5 mode.
- The instantaneous value (Lp) display always shows the
value at the pause point.