Instruction manual

Memory Functions

Manual (Frequency Analysis Mode)

Storing data in memory

At the point where the STORE key is pressed, the current instantaneous value and the

various processing results are stored in memory. The procedure is as described below.

1. Set the power switch on the side of the unit to ON

and wait until the measurement screen appears.

2. Press the MEMORY key to call up the MEMORY

menu screen.

3. Set the "MEMORY BLOCK" item to "MANU".

4. Press the SETUP key to call up the SETUP menu

screen.

5. Set "Leq Time", "TRIGGER MODE" and other

items to the desired settings.

6. Press the DISPLAY key to call up the DISPLAY

menu screen.

7. Set "MAIN ADD DISP" and other items to the

desired settings.

8. Press the DISPLAY key to return to the original

measurement screen.

9. Use the SLM / 1/1 1/3 key to activate the fre-

quency analysis screen.

10. Use the INC and DEC keys to select the memory

address in which to store the measurement data.

11. Press the START/STOP key to start the measure-

ment. The measurement will start according to the

trigger mode and other settings. When measure-

ment is in progress, the at the top of the display

and the LED indicator are flashing.

12. When the measurement is completed and the

STORE key is pressed, one set of data is stored in

the selected address.

The address counter indication at the bottom right

of the screen is shown in reverse, and the counter

is incremented by one.

13. By repeating the procedure from setup 11, more

data can be stored in memory. Use the INC and DEC keys to select the memory

address in which to store the measurement data.