Datasheet

1
Quick Guide
-DC9257AP
1
H92P
Connect to micro USB port of OTG device
2
H92P
3
* Before you use scanner, please switch to "C" for battery
charge for 3~4 hours.
* Under “C mode”, you can raise/lower soft-keyboard easily.
4
H92P
S
can
H
older is with Li
-
I
on battery inside. When in
charging, please use the original power adaptor of OTG
device (recommend). Through it, it charges both OTG
device and H92P internal battery at the same time. When in
low battery (Red LED flashing), please charge it
immediately.
LED Indicator Information
Green LED OFF
Full charged (Charge mode)
Green LED ON
Charging (Charge mode)
Red LED Flashing
Low battery
(
Op
era
tion mode)
Attention: Under “Operation mode” please do not charging,
otherwise the OTG device's battery will be charging back to
H92P’s battery.
5
The touch sensor area is around the central area. (For both sides).
Please check the above drawing for your reference.
Installation
Before using scanner, please make sure that the OTG device is fully
charged.
Under USB HID interface
** When plugged into OTG device, it will be recognized and begin
to scan the barcode.
Suction Cup
PU Glue
(Can be used repeatedly)
Micro USB cable
(OTG)
Li- Ion
Battery
Trigger Area
O = Operation mode C = Charge mode
LED Indicator
LED Indicator
Charge port
Mini
scanner