Instructions for use

WOTS WOT - Instructions

STEP 49

Connect the clevis to a control horn and position the horn so that it is in line

with the hinge line. Holding the horn in position, pilot drill the elevator for the

mounting screws.

STEP 50

Screw the control horn to the underside of the elevator allowing the mounting

screws to thread into the moulded horn plate on the top surface of the elevator.

STEP 51

Locate the closed loop horn and

install it in the rudder in line with

the slots in the fuselage using the

nuts and washers as shown. Use a

threadlocking compound on the nuts

to ensure they do not loosen due to

engine vibration.

STEP 52

Cut the supplied single piece of closed loop wire into two equal lengths, then

fit a clevis onto the closed loop adaptor. Now loop one piece of the closed loop

wire through the adaptor and slip the brass tube supplied over the join. Crimp

firmly with pliers or side cutters and add a drop of cyano for increased security.

Repeat for the second length of wire.

STEP 48

Locate the factory assembled elevator pushrod and slide it into position from

the radio bay and out through the exit slot. Screw a nylon clevis onto the rod

as shown.

STEP 53

Install your rudder and elevator servos in the pre-fitted servo tray as shown.

Note the orientation of the servo outputs. Note that there are two servo spacers

glued to the tray; these raise the height of the rudder servo for additional

clearance on the elevator servo.

Control

Horn

Threaded

Rod

Nut

Washer

Radio Installation