Instructions for use

WOTS WOT - Instructions

STEP 62

Holding the engine steady, mark the position of the mounting holes on the

mount as shown. Remove the engine and drill four clearance holes through the

engine mounting beams to suit the bolts supplied.

STEP 63

Screw the engine to the mount using the four bolts, washers and nuts supplied.

Locate the throttle pushrod outer sleeve. Install the tube through the bulkhead

and secure with a drop of cyano. Form a 'Z' bend in the throttle pushrod. Fit to

the carburettor throttle lever and slide the pushrod into its outer. To do this, you

will need to temporarily remove the throttle lever from the carburettor.

STEP 64

Prepare the fuel tank for fitting by assembling the tank stopper with the feed,

vent and fuel pipes. Ensure the clunk tube length is cut to allow the clunk to

move around the tank without catching on the tank's base. Fit the assembled

tank bung and tighten the retaining screw noting that the tank is fitted on its

side. Take care not to over-tighten this screw. Test that the tank is leak-proof.

STEP 65

The tank is installed in its bay via the radio bay. Fit and identify your fuel tubes,

then feed the tank into position, drawing the fuel tubes out through the hole in

the centre of the firewall. If installing a receiver battery below the tank, do this

now before the tank is fitted. Ensure that the battery is wrapped in foam.

STEP 60

Screw the engine mount onto the bulkhead as shown noting the orientation

of the mount. Use the supplied mounting screws and washers using thread

locking compound to secure. Note that the captive nuts have already been

factory installed in the bulkhead.

STEP 61

Place your engine on the mount. Adjust its position until the distance from the

front of the prop driver to the front of the main bulkhead (not plywood mount

plate) is 127mm.

Four Stroke Engine Installation