Instructions for use

WOTS WOT - Instructions

STEP 72

With the hatch removed, access to the Li-Po bay is gained.

STEP 73

Locate the fixed battery mount. Use a small amount of epoxy to glue the spacer

to the end opposite to the bolt hole.

STEP 74

Glue the cover plate over the spacer (shown dotted) to form a recess for the

tongue of the removable battery tray to locate.

STEP 75

Press in a captive nut from the underside of the fixed battery mounting plate as

shown and secure with 5 minute epoxy.

STEP 77

The 'tongue' on the removable tray locates in the ply pocket at the rear of the

fixed tray and a nylon bolt retains the plate. The removable plate has a keyhole

slot so that the retaining bolt needs to only be loosened to allow the plate to be

slid forward and removed to charge your Li-Po.

STEP 76

With the model upside down glue the fixed battery mounting plate in position.

The front should be flush with the bulkhead and the rear locates in the cabane

strut. Use five minute epoxy for this. Use the supplied piece of triangular balsa

under the front of the plate where it joins to the front former.

Recess

Cover Plate

Spacer Plate

Battery Mount

Attach your battery to the plate with

several layers of either electrical or

clear adhesive tape as shown.