Instructions for use

STEP 79

Mount your ESC as shown to ensure that it gets plenty of cooling air over it.

STEP 80

Use a sharp knife to open up the panel as shown on the underside of the model

to allow cooling air to exit.

STEP 81

Rigging the Wots Wot is quick and easy if you follow this simple step-by-step

guide. Fit the interplane struts to the lower wing using the bolts, washers and

nyloc nuts supplied.

STEP 83

Slide the wing tube through the cabane strut holding the wing level.

STEP 82

Slide the wing tube into the right-hand upper wing panel and tighten its

retaining screw. Connect a nylon clevis to the aileron linkage rod and attach to

the link horn on the upper aileron.

STEP 78

Install your choice of motor to the mounting plate using the screws, washers

and nyloc nuts supplied. Screw a threaded stud into the rear of each aluminium

stand-off. Now screw the stand-offs to the front former. Use pre-drilled hole

in each stand-off for a tommy bar to be used to tighten. Now fit the motor

mounting assembly to the stand-offs using the four screws and washers

supplied.

Rigging for Flight