Instructions for use

WOTS WOT - Instructions

STEP 12

Now screw the horn to the aileron. The screws thread into the moulded horn

plate on the top surface of the wing.

STEP 14

Use a small length of tape to hold each of the ailerons at their neutral position

while you complete the aileron linkages. Ensure that both aileron servos are

centred. Locate a threaded wire aileron pushrod and attach a nylon clevis to

the end. Connect it to the aileron horn and mark the position the control rod

passes over the servo’s output arm. Bend the pushrod up at 90° at this point.

STEP 15

Slide the aileron servo horn over the wire, re-fit to the servo and snap a moulded

keeper onto the pushrod to retain it. Trim off the excess pushrod wire using side

cutters. Repeat the procedure for the second aileron in exactly the same way.

STEP 16

Adjust the pushrods to ensure that the ailerons are centred with the aileron

servos at their neutral position. Test to ensure that both ailerons move freely

across their entire throw. Fit short lengths of fuel tube over each clevis to ensure

they cannot open under flight loads.

STEP 13

Do not overtighten the control horn mounting screws - you don't want to crush

the aileron. Turn the model over and trim off any excess thread using side

cutters.

STEP 17

Locate the pre-cut slot for the aileron link horn. Carefully trim the film away

from the upper side of slot as shown. Make sure that you do not cut through

the film on the underside of the aileron.