Instructions for use

6
WOTS WOT - Instructions
STEP 20
Using a sharp knife, carefully trim away the covering to expose the holes in
the underside of the wing, for the screws that thread into the wing joiner tube.
STEP 19
Hinge the ailerons using the same method as with the lower wing. Now locate
the nylon dowel and epoxy into one wing panel to act as an alignment peg.
STEP 21
The upper wing is joined with an aluminium wing joiner tube that is secured in
place with screws through these holes.
STEP 22
Using the same technique as the lower wing, roughen and glue the aileron
link horns in position on the underside of the ailerons. Note that the holes are
orientated towards the rear of the ailerons.
Completing the Upper Wing
STEP 18
Locate the fibreglass aileron link horns. Test fit the horn in its slot on the top
surface, noting that the hole is towards the rear of the aileron. Remove and
roughen the horn with coarse sandpaper. Epoxy in position with the base of the
horn flush with the bottom of the aileron.
145mm
140mm 140mm
145mm
STEP 23
Locate the four plastic
moulded interplane strut
mounts, and identify the
top and bottom mounts.
The lower mount is more
curved than the upper.
Scuff the locating tabs for a
good key when gluing.
Upper Strut Mount
Lower Strut Mount
Wing Leading Edge
Strut