Instructions for use

WOTS WOT - Instructions

STEP 29

Use epoxy to fix the pilot figure in position. Use strips of masking tape to retain

the figure while the adhesive cures.

STEP 26

Using a sharp knife, carefully trim away the covering from the pre-cut cabane

mounting slot in the top of the fuselage with a sharp knife.

STEP 24

Place the strut mount in position on the wing. Check that you have the correct

mounts - the top and bottom are shaped differently to suit the wing curvature.

Also check that the mounts are the correct way round by temporarily dry

assembling the model with the struts in place to ensure that the are correctly

oorientated. Using a sharp knife, carefully trim around the mount's outline as

shown.

STEP 25

Remove the film as shown and glue the mount in position using 5 minute epoxy.

Repeat for the other side of the wing.

STEP 27

Use strips of masking tape to protect the covering film from excess epoxy.

STEP 28

Noting the orientation of the cabane, apply sufficient epoxy onto the plywood

cabane and slide it fully into position in the fuselage so that the tabs sit flush.

Wipe off any excess epoxy then remove the masking tape before the adhesive

cures.

Fuselage

Front of model

Flush

Install up to this line.