Instructions for use

STEP 35

Screw the tailwheel bracket in position.

Now trim away the covering from the tailplane and fin mounting slots at the

rear of the fuselage.

STEP 32

Insert the axle through the undercarriage leg, fit a washer and tighten the

nyloc nut. Slide a wheel over the axle and retain with collet using a little thread

locking compound on the grub screw. Repeat for the other wheel.

STEP 30

Using epoxy or canopy glue, fit the canopy using strips of tape to secure while

the adhesive cures. Ensure that the canopy is correctly centred front to rear

and left to right. Alternatively the canopy can be secured with small screws if

preferred.

STEP 31

Locate the aluminium main undercarriage, wheels and wheel mounting

hardware (axles, collets, washers and nyloc nuts).

STEP 33

Install the main undercarriage using the two mounting screws and washers

supplied. For security, use thread lock compound on the screws.

STEP 34

Locate the pre-bent tailwheel assembly and fit the tailwheel using the supplied

collet. Hold the tailwheel bracket in position with the tailwheel wire inline with

the rear of the fuselage. Pilot drill holes for the retaining screws.

Undercarriage