User Manual

WOTS WOT - Instructions

STEP 54

With the elevator and servo centred, mark the point that the pushrod passes

the servo output arm. Use a wrap of masking tape on the rod to make marking

it easier if required. Bend the pushrod up at 90° at this point.

STEP 56

Slide a thin piece of wire forward through one of the closed loop exits in the

rear of the fuselage and feed it forward into the radio bay. Tape the closed loop

wire to this and use it to pull the closed loop wire out through the exit. Remove

the tape.

STEP 55

Slip the bent pushrod through the servo horn and fit a moulded

swing-in keeper. Now trim off the excess length of wire, refit

the horn and test the operation of the elevator.

STEP 58

Fit a clevis onto a closed loop adaptor and attach to the rudder's closed loop

horn. Now slip a length of the supplied brass tube over the closed loop wire,

pass the wire through the adaptor and back through the tube. Crimp the tube

carefully with pliers or side cutters and for additional security, add a drop of

cyano. Repeat for the second wire.

STEP 59

Install your receiver using foam backed double sided tape (if using an electric

powerplant) or use foam rubber if using an I/C engine.

Radio Installation

Elevator

Servo

Rudder

Servo

STEP 57

With the servo and rudder centred, connect the closed loop wires to the servo

horn as shown. .