Use and Care Manual
ENGLISHESPAÑOLFRANÇAIS
7
OPERATING INSTRUCTIONS
Getting Started and Bluetooth® Pairing
1. Use unit’s Power switch on the back panel to turn unit ON (I Position).
2. Once the unit is turned on, you will see a slowly blinking blue indicator light. In this
mode, the unit’s Bluetooth mode is turned on, but is not in pairing mode. [If you have
already paired and connected a device, the blue LED will be steadily lit.]
3. Press the Bluetooth Pairing button for 4 seconds to have the speaker system
enter pairing mode. The speaker will beep twice and the blue indicator light will flash
rapidly, putting the speaker in Bluetooth pairing mode for approximately 10 minutes
(before turning pairing o again).
4. Activate your other device’s Bluetooth function (you might refer to your device’s us-
er’s guide). The speaker should connect to any Bluetooth certified device within 30
feet..
5. When “Mavis” appears in the Bluetooth devices list, pair it to your device. Once the
device is paired & connected to the Speaker’s Bluetooth receiver, the indicator light
will turn to steady blue, and the speaker should emit a single beep.
Playing Music Through Bluetooth (aer Pairing)
1. You can control the speaker through your device or with the speaker’s Play/Pause
and Volume ( and ) buttons, found on the top panel.
2. If a smartphone is connected and you receive a call during playback, answering the
call using the phone will put the speaker into standby mode & it will mute. Once the
call is disconnected, the speaker will resume playback automatically (provided the
phone is using a compatible Bluetooth version).
3. If the connected device moves too far away from the speaker (usually more than 30
feet or less if blocked by walls, for example) the speaker disconnects from the device
but will attempt to resume connection once the device is closer.
Playing Music Through Auxiliary input Jack
The unit also supports listening and playing media o other
non-Bluetooth devices as follows:
1. Plug in the high quality 3.5mm (1/8”) male-to-male connector auxiliary cable (includ-
ed) into the Aux-In jack on the rear of the unit and connect the other end to the line-
out or headphone jack of any standard audio device.
2. Once the AUX cable is attached to the back panel port labeled AUX, the status indi-
cator light will turn amber, indicating unit is using line in mode instead of Bluetooth
mode.
3. Both the top panel volume buttons and the connected device’s controls can be used
to adjust the volume. Play music from your attached device as usual. User your
device’s controls for music/song control adjustment. It is a good idea to keep your
device’s volume level lower than the maximum to ensure sound quality.
4. Once the AUX cable is disconnected from back panel of unit, the speaker will contin-
ue Bluetooth operations & indicator light will turn BLUE.