User's Manual

Page 2
LED Indications
LED State Description
On AC and batteries OK
Flashing AC trouble or Low battery (below 3.1 VDC)
(Red) =
Power
Of f Power not present
On X10 Connected to the Wireless I/O Module
(Yellow)
X10
Of f X10 Disconnected
On The I/O expander is communicating with the Agility
(Green)
Communication
Of f No communication is taking place
Mounting the Wireless I/O Module
Select a mounting location near an AC power supply in proximity to the Agility main panel
1. Open the cover by twisting a screwdriver in the slots on the bottom or top of the case
(Figure 2).
Figure 2: Opening the Cover
2. Remove the circuit board ( Figure 3 ) and open knockouts for the entry of the power wires
(1, Figure 4) and for the back tamper (2, Figure 4).