Operation 8035C MENU PROG RESET ENGLISH MENU PROG RESET Customer Support: 888-515-2585 or Visit our webiste Made in China www.ritetemp-thermostats.
Operation 8035C Using a TOUCH SCREEN Time of day MENU Day Time Slot Touch Screen PROG Menu button Current Room Temperature Program button Target Temperature Thermostat Mode RESET Fan Switch Statement of use: The GPMG8035C can be used with most 24 volt gas, oil or electric heating and air conditioning systems, single-stage heat pumps or gas millivolt heating systems. It cannot be used with 120 volt heating systems or multistage heat pumps.
Set Time Touch this area to set Displayed when the MENU the time of day. button is pressed from the Left arrow goes back, HOME screen. right arrow goes forward. MENU screen Set Day Touch this area to set the day of the week. Return HOME Temperature Swing set Set C - F Touch this to set temperature display. o o Calibration Use this to calibrate your LCD display to match another thermometer.
1 Configure ï Press MENU to configure the thermostat (from HOME screen). ï Set day of the week Touch the Day of the week area to cycle through the days of the week to select the current day. ï Set time of day Touch the Time of Day arrows to move the time selection forward or backward until it displays the current time. Touch and hold for faster setting. ï Set C - F display Touch the F and it will toggle to o Backward Forward o o o C.
3 Program NOTE: 60 Second Rule-During programming, if a button is not pushed in 60 seconds, the unit will return to the home screen. Everything you have changed while programming will automatically be saved. ï Press PROGRAM to go to the programming screen. ï Select HEAT with the HEAT/Cool MODE switch. ï Select the day you want to programTouch the Day of the week area to cycle through the days of the week to select the desired day.
Return HOME Manual The 8035C has 3 manual override commands. These are Target accessed by touching the Temperature Current Temp Display at the HOME screen (center of HOLD screen). Touch this area to set a comfortable target temp for the system to hold until you return and remove HOLD. Temp Up / Temp Down arrows Touch these to raise and lower the manual override Target Temp. Manual Override indicator Shows you have temporarily modified the Target Temp. MANUAL Temporary Override screen PG 9 Manual cont.
4 Special Features Swing ï Swing setting determines the temperature difference from ON to OFF that the thermostat will command the HVAC system to run. ï With the MODE switch in HEAT or COOL, press the MENU button. ï Touch the SWING icon and the current setting of temp swing is shown on the display (default at 3 ). ï To change the swing, touch the left or right arrows. The furnace will cycle more at the lower numbers as it tries to keep your set point constant.
12/24 hour ï The thermostat can display time in 12 or 24 hour formats. At the HOME screen touch the time display to toggle from 12 to 24 hr display. Calibration o NOTE: Your thermostat comes from the factory calibrated to + or - 1 F actual temperature. It is an accurate instrument. If you want your thermostat to display the same temperature as another thermometer in your home, you can adjust its calibration. To change the calibration: ï The unit must be in the HEAT or COOL mode. ï Press the MENU button.
