¤ JOBCOM ® JMX "D-SERIES" OWNER'S MANUAL "D-SERIES" HANDHELDS COMPACT, ULTRA-SMALL PROFESSIONAL TWO-WAY RADIOS Up to 10 channel capability Easy to read LED display 1.
ACCESSORIES OPTIONAL ACCESSORIES: TO ORDER, CALL 1-800-USA-1-USA. BPJS-6N .......... Spare/ Replacement JMX Battery BPS-6N-SC ..... Spare/ Replacement SST Battery BPS-6N-MH .... Replacement High Capacity Battery RHD-1X Single Ear Headset RHD-6X Behind-the-ear Earset BCJS-AD Single-Well Drop-in Charger AFS-150 .......... VHF Molded Flex Antenna AFS-450 .......... UHF Molded Flex Antenna BPS-6N-SC Spare Battery RHD-1X ............ Single Ear Headset RHD-4X ............ Dual Ear Headset RHD-5X .......
TABLE OF CONTENTS DESCRIPTION ..................................................................................... PAGE ACCESSORIES Optional Accessories ................................................................................................. i i INTRODUCTION JMX "D-Series" Model Numbers .............................................................................. 1 Features .....................................................................................................................
INTRODUCTION THANK YOU FOR CHOOSING RITRON Congratulations on your purchase of the JMX "DSeries" radio. Your new radio is the culmination of Ritron's 25 years of designing, manufacturing, and supplying reliable, professional wireless communication products. Ritron wireless products will improve the operation, safety, and profitability of any organization by providing instant voice communications between employees throughout the workplace.
CONTROL & OPERATION 1 ANTENNA The flexible antenna radiates and receives radio signals. Screw the antenna base all the way into the threaded bushing on top of the radio. NOTE: 2 Use only the type of antenna furnished with the radio. VHF and UHF antennas are not interchangeable. ON/ VOLUME UP To switch the unit On, press the On/ Volume Up button; the speaker will emit a turn on beep. If the radio turns on to the Scan Channel it will emit the Scan Beep.
OPERATION ON-OFF / VOLUME ADJUST RECEIVE To switch on the radio - press the On/Volume Up button. The radio will emit the Channel beep. If the radio turns on to the Scan Channel it will emit the Scan Beep. The radio will always turn on to the channel that was selected when it was last turned off. To hear calls from other users - adjust the volume as desired. The radio can only receive broadcasts while the Push-To-Talk button is not being pressed.
OPERATION TRANSMIT OPTIONAL ALERT TONES Normally, you should not transmit until the channel is quiet. This can be determined by monitoring the channel prior to transmitting. To transmit - hold down the Push-To-Talk button and with the radio four inches away talk into the microphone. Speak in a normal tone, since talking louder will not improve the listeners reception.
OPERATION CHANNEL SCAN OPERATION Channel scanning allows you to listen to broadcasts on your radio channels. The JMX "D-Series" will scan all channels programmed into the radio except the NOAA Weather Channel. How Scanning Works Using the Channel Selector button, select the Scan Channel. The radio sounds the Scan Beep, and then repeatedly checks each channel in the scan list. The channel display will show the channel numbers as they are scanned.
NOAA WEATHER RADIO HOW TO PRESET YOUR RADIO FOR LOCAL NOAA WEATHER BROADCASTS NOAA WEATHER CHANNEL 1. PRESS & HOLD UNTIL THE "RADIO OFF" TONES ARE HEARD, THEN RELEASE. (VHF MODELS ONLY) VHF models of the JMX "D-Series" radio can hear weather forecasts from the National Weather Service which are broadcast on one of the seven NOAA weather frequencies. In some areas you may be able to receive more than one broadcast. The radio is shipped from the factory without a NOAA frequency selected.
RADIO PROGRAMMING HOW TO READOUT FIELD PROGRAMMED FREQUENCY & TONE CODES 1. Place the radio into Program/ Readout Mode by following the instructions in FIG-6 at left. A "P" will appear on the LED display as you enter program mode. 1. PRESS & HOLD UNTIL THE "RADIO OFF" TONES ARE HEARD, THEN RELEASE. CHANNEL 2. Using the Channel button and the LED display on the front of the radio, select the channel number you wish to readout. 3.
RADIO PROGRAMMING TABLE 1: PROGRAMMABLE FREQUENCY CODES PTT CLICK FREQ. CODE VHF Business Band MHz Frequency color PTT CLICK FREQ. CODE Green Dot ^ Blue Dot ^ Red Dot * Purple Dot MHz Frequency color 01 02 03 04 467.7625 467.8125 464.5500 464.5000 J K Yellow Dot * Brown Dot * 01 02 03 04 154.600 154.570 151.625 151.955 05 06 07 08 151.925 154.540 154.515 154.655 05 06 07 08 467.8500 467.8750 467.9000 467.9250 Silver Star Gold Star Red Star Blue Star 09 10 11 12 151.685 151.715 151.775 151.
RADIO PROGRAMMING HOW TO FIELD PROGRAM FREQUENCY & TONE CODES To match other radios, the owner can select Frequency and Tone Codes from Tables 1 and 2 on page 8. 10. Using the PTT (push-to-talk) button and the LED display, select the 1st digit of the 2-digit tone code (or No Tone code "44") you wish to program into the radio. 04 12 1. Refer to Table 1 on page 8 to determine the two digit frequency code and write it down. 2. Refer to Table 2 on page 8 to determine the two digit tone code for 100.
RADIO PROGRAMMING HOW TO: DELETE A CHANNEL 1. Follow the instructions in FIG-6 on page 7 to place the radio in the Program/ Readout Mode. 2. Using the Channel button and the LED display on the front of the radio, select the channel to be deleted. 3. Enter 4-digit code "0000" as described in the "How to Field Program Frequency & Tone Codes" section on page 9. 4. When all four digits are programmed, press and release the On/Volume Up to SAVE your programming entry.
BATTERIES FIG7: BATTERY ACCESS & INSTALLATION: BATTERY ACCESS DOOR (A) OPTIONAL CHARGING ACCESSORIES: 4. 5. DOOR LATCH 6. 1. 2. Hold the radio as shown above (A). 3. Lift and rotate the Battery Access Door to release it (C). Use your thumbnail to open the Door Latch, as shown below (B). 7. (C) Use the Pull-tab to pull the battery pack out of the case (D). Insert the replacement battery pack, being certain to POSITION IT RELATIVE TO THE CASE AS SHOWN IN (D).
BATTERIES CAUTION: Use only RITRON-supplied chargers; using other chargers may cause fire or explosion, or otherwise damage the radio. CHARGING The JMX "D-Series" radio is powered by a rechargeable battery pack. Because the battery pack loses its charge during storage and shipment, fully charge it before first use. To ensure peak radio performance for the next day, charge the battery overnight after each day of use. It completely charges in about ten hours.
!! CAUTIONS ALL RADIOS !! OBSERVE CAUTION IN THE FOLLOWING ENVIRONMENTS TO MAXIMIZE THE LIFE OF YOUR RADIO EQUIPMENT: MOISTURE: JMX "D-Series" radios are not waterproof. DO NOT directly expose them to rain or excessive moisture. CHEMICALS: Detergents, alcohol, aerosol sprays or petroleum products can damage the radio case. DO NOT use petroleum solvents of any kind; use a soft cloth moistened with water to clean the case. EXTREME HEAT: High temperatures can damage the battery and other components.
TROUBLESHOOTING NOTES 1. Try a battery pack from a working radio. If the radio in question works with that pack, the original battery is suspect. Charge the suspect battery as recommended in this manual. If this original battery cannot power the radio, try charging it again with another charger. If the battery still doesn't hold a charge, the pack should probably be replaced. If the battery appears to be "good" after using the second charger, the first charger may be faulty.
FCC LICENSE REQUIRED FCC REGULATIONS HOW TO OBTAIN AN FCC RADIO LICENSE LICENSING The FCC requires the owners of the radios to obtain a station license before using them. The station licensee is responsible for ensuring that transmitter power, frequency and deviation are within the limits specified by the station license. The station licensee is also responsible for proper operation and maintenance of the radio equipment.
RITRON, INC. LIMITED WARRANTY WHAT THIS WARRANTY COVERS RITRON, INC. ("RITRON") provides the following warranty against defects in materials and/or workmanship in RITRON Radios, Rechargeable Batteries and Accessories under normal use and service during the applicable warranty period (as stated below). "Accessories" means antennas, holsters, chargers, earphones, speaker/microphones and items contained in the programming and programming/ service kits.
Designed to work as an integrated system or as an add-on to virtually any existing two-way radio system Quick Talk TM Wireless Voice Alarm Reporter for Remote Monitoring of any sensor or switch OutPost TM XT Ruggedized Two-Way Callbox OutPost TM Basic Two-Way Callbox Quick Assist ® II Push-Button RF Transmitter Battery-operated callboxes provide instant wireless communication over existing two-way radio systems Wireless Intercom/Base Station Desktop or Wall Mountable Radio Pub. 14500033 REV.