User's Manual
page 3 RITRON, INC. 1-800-USA-1-USA
(1-800-872-1872)
Have questions? Call
1-800-USA-1-USA
(1-800-872-1872) or visit our website at www.ritron.com
TO DETERMINE FREQUENCIES & CODES IN "FOUR SERIES" JMX/ SST
page 4
a. Ten (10) beeps = 0 (zero).
b. The radio will beep out "44" as an interference eliminator code if it was programmed for "No Tone."
c. A radio that was PC-programmed with any frequency or tone not listed in Table 1or 2 on page 5,
the radio will sound the error tone on contents "beepout."
*
The radio pauses to sound a low tone at the end of each set of beeps.
SELECT EACH CHANNEL TO BEEP OUT (READ OUT) CHANNEL CONTENTS:
1. To enter the Programming/ Readout Mode, refer to FIG-4 at left.
2. YOU MUST Press the Channel Selector button to select the channel to be read out.
3. Press and release the On/ Volume Up button.
The radio will begin to sound a series of beeps; each set in the series equals one digit of each two-digit
(frequency code/ interference eliminator code) code in the radio; see Tables 1 and 2, opposite.
4. Count the beeps in each set. Write down the number of beeps for each digit in the spaces provided below.
EXAMPLES: 2 beeps = 2; 10 beeps = 0 (zero).
5. To read out another channel, follow steps 2 through 4. When you are finished, complete step 6.
6. Turn the radio off.
NOTES:
*
The radio pauses to sound a low tone at the end of each set of beeps, separating one digit from the next.
The radio sounds a triple beep when the readout (beep out) process is complete.
FIG-4:FIG-4:
FIG-4:FIG-4:
FIG-4:
TO PLACE THE RADIO INTO PLACE THE RADIO IN
TO PLACE THE RADIO INTO PLACE THE RADIO IN
TO PLACE THE RADIO IN
PROGRAM/ READOUT MODEPROGRAM/ READOUT MODE
PROGRAM/ READOUT MODEPROGRAM/ READOUT MODE
PROGRAM/ READOUT MODE
IMPORTANT:
To talk to other users in your group, all radios
must be set to the same frequency and
Interference Eliminator codes.
ON
OFF/HOLD
VOLUME
3. PRESS & RELEASE.
The radio will start
beeping rapidly.
CH
2. PRESS & HOLD.
4. CONTINUE HOLDING THE PTT
UNTIL THE BEEPING STOPS,
THEN RELEASE IT.
The radio will emit a triple tone:
it is now in Program/ Readout Mode.
1. PRESS & HOLD UNTIL
THE "RADIO OFF"
TONES ARE HEARD,
THEN RELEASE.
FREQUENCY CODE: INTERFERENCE ELIMINATOR CODE:
CH. 1
CH. 2
CH. 3
CH. 4
1st digit 2nd digit
# of beeps
*
# of beeps
3rd digit 4th digit
# of beeps
*
# of beeps
1st digit 2nd digit
# of beeps
*
# of beeps
3rd digit 4th digit
# of beeps
*
# of beeps
1st digit 2nd digit
# of beeps
*
# of beeps
3rd digit 4th digit
# of beeps
*
# of beeps
1st digit 2nd digit
# of beeps
*
# of beeps
3rd digit 4th digit
# of beeps
*
# of beeps
CHANNEL:
*
*
*
*
SELECT THE CHANNEL NUMBER YOU WISH TO READ OUT:
NOTES: