User's Manual

Have questions? Call

800-USA-1-USA

(800-872-1872) or visit our website at www.ritron.com

How To Read-Out Frequency and Tone Code Settings

Step 4. Radio will then display [READY] and return to normal operation.

Step 5. To read-out a different channel repeat steps 1-4 for each channel.

Step 6. Turn radio OFF then ON again to return to normal operation.

Note: If no Tone Code is programmed, the display will read: [ T 4 4 2T X ] 44 = No Tone

* If no

2-Tone Code is programmed, display will read: [ 2T X ]. 2-Tone feature not available in all J Series models.

This step allows you to read-out on a per-channel-basis what the frequency code and interference eliminator

tone code settings are in your radio.

Step 1. With radio ON, select the channel # you want to read-out.

Step 2. Turn radio OFF,

Step 3. HOLD the button and Turn radio ON.

Note: Continue to HOLD button until the following appears on the display:

Frequency Tone 2-Tone*

Ch # Code # Code # Code #

Display will read for 3 seconds = [CH _ _ F _ _ ] then . [T _ _ _ 2T _ ]