User's Manual

For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
4
1
2
3
4
5
6
9
10
7
8
IDENTIFICATION OF QUICK ASSIST
®
CONTROLS AND CONNECTIONS ....................................................................
1 Battery Holder
The battery holder accommodates the six (6)
standard “AA” alkaline cells required to power the
Quick Assist
®
.
NOTE: Always install a fresh set of alkaline
batteries before programming the unit.
2 Front Panel LED
The red front panel LED is lit whenever the Quick
Assist
®
is transmitting a message.
3 SMB Antenna Connector
This connects the internal antenna to the radio
printed circuit board.
4 External Audio Input
Allows input to the Quick Assist
®
voice recorder
from an external audio source, such as the Line
Out audio from your computer.
5 Microphone
Microphone for recording voice messages.
6 USB Programming Connector
Connects the Quick Assist
®
to the USB port on your
computer for programming.
7 Record Button
Press this button to initiate voice recording.
8 Internal Antenna
The internal antenna radiates radio signals.
9 Front Panel Push Button
When the front panel push button is pressed the Quick
Assist
®
transmits your pre-recorded voice message. This
sealed push button provides a water-resistant enclosure.
10 Battery Connector
In-line connector between the printed circuit board and the
battery holder.
IMPORTANT
: Do not remove any other fasteners or further
disassemble the Quick Assist
®
unit; doing so risks damage to
the unit and voiding the manufacturer’s warranty.
FIG-1: CONTROLS & CONNECTIONS