User's Manual
For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
3
1
2
3
4
5
6
8
9
10
11
7
IDENTIFICATION OF QUICK TALK
TM
CONTROLS AND CONNECTIONS .....................................................................
1 Battery Holder
The battery holder accommodates the six (6)
standard “AA” alkaline cells required to power the
Quick Talk
TM
.
NOTE: Always install a fresh set of alkaline
batteries before programming the unit.
2 BNC Antenna Connector
The antenna radiates radio signals. Before using
Quick Talk
TM
, make sure the antenna is fastened
securely to this connector on the front of the radio.
3 SMB Antenna Connector
This connects the front-panel, BNC antenna
connector to the radio printed circuit board.
4 External Audio Input
Allows input to the Quick Talk
TM
voice recorder
from an external audio source, such as the Line
Out audio from your computer.
5 Microphone
Microphone for recording voice messages.
6 USB Programming Connector
Connects the Quick Talk
TM
to the USB port on
your computer for programming.
FIG-1: CONTROLS & CONNECTIONS
7 Record Button
Press this button to initiate voice recording.
8 External Hook-up Cable
A 10-conductor cable for connection of external power supply
and up to four (4) switch inputs.
9 Watertight Strain Relief Cable Fitting
The cable to your external switches passes through this
fitting. When the strain relief fitting is used with
recommended cable sizes, it provides a water- resistant
enclosure. Do not overtighten this fitting.
NOTES: Use Radio Shack Telephone Station Wire, 6-
conductor, solid 24-AWG In-wall Type CM, Cat. No. 278-874,
or equivalent size round cable (0.114 — 0.250” diameter).
If you cannot find suitable wire, call Ritron at 800-872-1872.
10 External Hook-up Connector
A 10-position connector for the external hookup cable.
11 Battery Connector
In-line connector between the printed circuit board and the
battery holder.
IMPORTANT
: Do not remove any other fasteners or further
disassemble the Quick Talk
TM
unit; doing so risks damage to
the unit and voiding the manufacturer’s warranty.