User's Manual

For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
7
Programmable RQT Radio Attributes
Latch On - When Latch On is selected, the RQT will
ignore decoded signals from the keyfob until after the
transmission schedule have been completed. If not set,
the RQT will transmit the recorded message every time
is receives the correct code.
EXAMPLE:
RQT-KEYFOB-1 is scheduled for 2 transmissions, 30
seconds between transmissions. When RQT-
KEYFOB-1 has been decoded the recorded message
will be transmitted twice with 30 seconds in between,
and any additional signals from RQT-KEYFOB-1 will
be ignored until 30 seconds after the message is sent
the 2
nd
time. Signals from other keyfobs will still be
heard, only RQT-KEYFOB-1 will be ignored.
Input Operation - can be set for 1 of 3 different modes:
Normal
operation considers the RQT-KEYFOB code as
it is received.
Dwell
operation requires the keyfob code to be present
continuously for a specified period of time before
considering.
Holdoff
operation requires that the keyfob code is not
present for a specified period of time before it is
considered.
EXAMPLE:
RQT-KEYFOB-2 set for 1 min. holdoff. When the
RQT-KEYFOB-2 code is received the recorded
message will play. Any additional signals from RQT-
KEYFOB-2 will be ignored until after 1 minute has
elapsed.
Number of Message Transmissions - specifies the
number of times a recorded message will be transmitted
after an RQT-KEYFOB code has been received.
Time between Transmissions specifies the length of
time between scheduled transmissions. If it is set to “No
Message”, the recoded message will not play. If it is set
to “On Changes Only”, the recorded message will only
play when the keyfob code is decoded.
Play Message on each Transmission specifies the
number of times the recorded message will be repeated
on each transmission.
EXAMPLE:
RQT-KEYFOB-1 is scheduled for 2 transmissions, 30
seconds between transmissions, 2 messages per
transmission. When RQT-KEYFOB-1 has been
decoded the recorded message will be transmitted
twice, wait 30 seconds, then the message is
transmitted twice again.