User's Manual
For assistance, call RITRON at 800-872-1872, or go to www.ritron.com
13
1
2
3
4
5
6
9 10 11
7
IDENTIFICATION OF QUICK TALK
TM
CONTROLS AND CONNECTIONS ...............................................................................................
1 Battery Holder
The battery holder accommodates the six (6) standard
“AA” alkaline cells required to power the Quick Talk
TM
.
NOTE:
Always install a fresh set of alkaline batteries
before programming the unit.
2 BNC Antenna Connector
The antenna radiates radio signals. Before using Quick
Talk
TM
, make sure the antenna is fastened securely to this
connector on the front of the radio.
3 SMB Antenna Connector
This connects the front-panel, BNC antenna connector to
the radio’s printed circuit board.
4 External Audio Input
Allows input to the Quick Talk
TM
voice recorder from an
external audio source, such as the Line Out audio from
your computer.
5 Microphone
Microphone for recording voice messages.
6 USB Programming Connector
Connects the Quick Talk
TM
to the USB port on your
computer for programming.
7 Record Button
Press this button to initiate voice recording.
8 External Hookup Cable (not shown)
A 10-conductor cable for connection of external power
supply and up to four (4) switch inputs.
9 Watertight Strain Relief Cable Fitting
The External Hookup cable to your external switches
passes through this fitting. When the strain relief fitting is
used with recommended cable sizes, it provides a water-
resistant enclosure. Do not overtighten this fitting.
NOTES: Use Alpha Wire 1219C/10, 10-conductor #24
AWG cable with an outside diameter of 0.25” for a
watertight fit.
If you cannot find suitable wire, call Ritron at 800-872-
1872.
10 External Hookup Connector
A 10-position connector for the external hookup cable.
11 Battery Connector
In-line connector between the printed circuit board and the
battery holder.
IMPORTANT: Do not remove any other fasteners or
further disassemble the Quick Talk
TM
unit; doing so risks
damage to the unit and could void the manufacturer’s
warranty.
FIG-6: Controls & Connections