User's Manual

RBS-SERIES DMR/ANALOG BASE RADIO USER MANUAL RADIO OPERATION - GENERAL

Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com 7

Send 2-Tone The base radio can transmit a 2-Tone code to selectively signal other radios or radio operated devices.

 Press and release the P2 BUTTON until “Send 2-Tone” appears on the display.

 With “Send 2-Tone” on the display, press the PTT button and the radio transmits a 2-Tone code from the

Analog Contacts list on the channel currently selected.

 If you continue to hold the PTT button down, the transmitter will remain active and voice communications

can be made after the 2-Tone has been sent.

 The 2-Tone code will be heard on the radio speaker as it is being sent.

 Sending the 2-Tone code is a one-time occurrence, to resend the 2-Tone code it must again be selected

with the P2 BUTTON.

 This feature is only available on Analog channels.

Send Selcall The base radio can transmit a Selcall code to selectively signal other radios or radio operated devices.

 Press and release the P2 BUTTON until “Send Selcall” appears on the display.

 With “Send Selcall” on the display, press the PTT button and the radio transmits a 3-9 digit Selcall code

from the Analog Contacts list on the channel currently selected.

 If you continue to hold the PTT button down, the transmitter will remain active and voice communications

can be made after the Selcall code has been sent.

 The Selcall code will be heard on the radio speaker as it is being sent.

 Sending the Selcall code is a one-time occurrence, to resend the Selcall code it must again be selected with

the P2 BUTTON.

 This feature is only available on Analog channels.

Send DMR The base radio can transmit a specific Group or Individual ID to selectively signal other radios or radio operated

devices.

 Press and release the P2 BUTTON until “Send DMR” appears on the display.

 With “Send DMR” on the display, press the PTT button and the radio transmits a Group or Individual ID from

the DMR Contacts list on the channel currently selected.

 The DMR Contact Name will appear on the radio display. If you continue to hold the PTT button down, the

transmitter will remain active and voice communications will be made.

 “Send DMR” is a one-time occurrence, to resend it must again be selected with the P2 BUTTON.

 This feature is only available on DMR channels.

Last Call The base radio can be quickly set to the last channel that received a call.

 Press and release the P2 BUTTON until “Last Call” appears on the display.

 The radio will go to the channel on which the most recent call was received.

Paging Reset Reset the base radio for Paging Decode on Analog channels.

After a Paging Code has been successfully decoded on an Analog channel it will not be required for

subsequent received signals until it has been reset. This can be done by programming a timed automatic reset,

or by resetting with the P2 Button.

 Press and release the P2 Button until “Paging Reset” appears on the display.

 The base radio must now receive the Paging Code before receiving voice transmissions from other radios.

 The selected radio channel must be programmed for Paging Decode for this feature to have any effect.

 This feature is only available on Analog channels.