Data Sheet

Technical System Catalogue/Climate control
Wall-mounted cooling units
3 - 30
Integrated into TopTherm cooling units
Condensate arising inside the enclosure or on the evapora-
tor coil of the cooling unit is effectively evaporated. The inte-
gral evaporator device of the cooling units has a very high
evaporation output (several litres per day).
This is achieved thanks to the principle of direct evaporation.
Important note: The enclosure must be sealed on all sides
(minimum IP 54).
Energy-efficient: Activation of the evaporator device is via a
separate heater cartridge. “Condensate evaporation” based
on the hot gas bypass principle is not effective, due to inade-
quate evaporation temperatures.
Advantage:
 Safe use: No condensate drips onto the factory floor
(no puddles/no risks of slipping/accidents).
 No need to empty the condensate collecting receptacles.
 No time-consuming laying of condensate hoses required.
Condensate evaporation, electrical
The Rittal condensate evaporators are active “direct evapo-
rator coils”, which actively evaporate the condensate
incurred.
Advantage:
 No collecting vessel required
 No long hosepipes
Note:
For roof and wall-mounted units, either external evaporator
units or integral condensate evaporators may be used.
TopTherm cooling units are available with integrated elec-
tronic condensate evaporation and external evaporator units
for retro-fitting.