Data Sheet
3 - 38
Liquid cooling
Technical System Catalogue/Climate control
1 Air/water heat exchanger
Liquid cooling classics
The temperature of the air inside the enclosure interior may
also be cooled to a level below that of the external air by
using air/water heat exchangers in conjunction with a cen-
tral re-
cooling system. Dust is unable to penetrate the enclosure.
The waste heat from the enclosure does not raise the tem-
perature of the ambient air, provided the cold water supply
system is remotely located.
For extremely hot and dusty ambient conditions
To dissipate high heat loads without putting thermal
pressure on the ambient air
2 Cold Plate
Direct cooling of power electronics inside the
enclosure
Liquid-cooled partial mounting plate with copper or stain-
less steel pipes press-fitted onto the rear, integrated into
closed recooling systems or into the existing water infra-
structure. With the pitch of Rittal partial mounting plates,
installation into the TS 8 top enclosure system is child’s
play using system accessories with a 25 mm pitch pattern.
At the same time, however, a 4-point attachment facility
permits direct mounting on the mounting plate or any other
surface.
Using liquid-cooled mounting plates (Cold Plate)
No impairment to the protection category
With efficient frequency converter cooling
3
Chillers for water
Energy-efficient cooling of liquid cooling media
Chiller systems are a centralised, efficient means of provid-
ing cooling either directly or via complementary equip-
ment using a fluid medium, typically a mixture of water and
gycol. For example, all cooling requirements on a system
or machine, whether they are for the process or control
equipment, may be satisfied using a single scheme. The
spatial seperation of the cooling supply and the process
to be cooled may be achieved using a chiller.
A high level of temperature accuracy
Powerful performance
Individual system solutions