Data Sheet

Technical System Catalogue/Climate control3 - 77
Flexibility
Climate control modules of various cooling outputs, may be
positioned on the door, rear panel, side panel or roof of the
modular enclosure.
The climate control modules provide flexibility of installa-
tion with three mounting positions, full internal, partial inter-
nal or external and the choice of between cooling via the
front or rear door of the CS Toptec.
Suitable for use within a temperature range from –33 °C
to +55 °C (cooling units) or +65 °C (heat exchangers).
Many units feature an integral heater.
Standardised installation
The full 25 mm double wall takes care of heat exchange
and minimises the influence of sunlight, featuring an active
climate control concept with fixed cut-out sizes and a
mounting frame for depth-variable positioning of the cli-
mate control unit. Depending on the local conditions at the
installation site, either a heat exchanger or a cooling unit
may be used.
Quality
Maximum cathodic edge protection is achieved by the
choice of materials. Additional zinc phosphating signifi-
cantly enhances the protective effect of galvanising. The
subsequent high-quality powder coating offers additional
protection and allows individual colouring.
Optimum rust-proofing at a moderate cost – Analyses by
neutral laboratories underscore our high quality standards.