User manual

Rittal enclosure cooling unit 13
5 Installation
EN
 Lift up the cooling unit, preferably from a lifting eye us-
ing suitable lifting gear, and initially set the cooling unit
down with the two bottom threaded bolts on the door
or side panel of the enclosure.
 If transportation by crane is not possible, lift the cool-
ing unit into the mounting cut-out in the same way us-
ing the handle.
Fig. 9: Threaded bolt in door cut-out
Key
1 Inside of enclosure door
2 Threaded bolts at bottom (2x)
3 Cooling unit on the outside of the enclosure door

Slide the cooling unit into the mounting cut-out at the
top until the clip behind the cut-out latches home.
Fig. 10: Clip in mounting cut-out
Key
1 Inside of enclosure door
2 Clip

Attach the two corner brackets to the threaded bolts
at the top and secure with the corresponding nuts.
Fig. 11: Corner brackets on the threaded bolts
Key
1Corner bracket
2 Threaded bolt

Next, attach the two corner brackets to the threaded
bolts at the bottom and secure with the corresponding
nuts.
Fig. 12: Threaded bolts at rear
Key
1 Threaded bolts (4x)
2 Fastening clamps (6x)
3 Rear of cooling unit
4 Cooling unit in front of enclosure door

Insert the six fastening clamps into the rear of the cool-
ing unit.