User manual

Rittal enclosure cooling unit 15
5 Installation
EN
Fig. 15: Attachments on hinge mechanism
Key
1Cover
2 Stays in hinge mechanism
3 Bracket
4 Bottom louvred grille

Pull the bottom louvred grille forwards out of its hold-
ers, and place or lay it down somewhere safe.
Fig. 16: Bottom holders of louvred grille
Key
1 Bottom louvred grille
2Holders
 Gently pull the infill panel including display forwards to
release it from the mounting clips on the cover.
Fig. 17: Remove the infill panel
Key
1 Mounting clips
2Cover
3 Infill panel

On the rear of the display, disconnect both of the con-
nectors (PE conductor and connection) and remove
the infill panel completely from the cooling unit.
Fig. 18: Connection point on the rear of the cooling unit
Key
1 Connection point

Place the infill panel somewhere safe.
 Carefully push the connector including connection ca-
ble inwards through the cable gland in the cover.
Fig. 19: Cable gland in the cover
Key
1Cover
2 Cable gland