User manual

Rittal enclosure cooling unit 17
5 Installation
EN
Fig. 23: Clip on the top edge of the chassis
Key
1 Outside of enclosure door
2 Clip in chassis

Make sure that the clip behind the cut-out is fully
snapped in towards the top.
Fig. 24: Mounting of the wedge element
Key
1 Outside of enclosure door
2 Clip in chassis
3 Wedge element

Please also insert the wedge element from the exterior
up to the stop in order to fasten the clip in the upper
position.
Fig. 25: Fully inserted wedge element
 Set the cover down at the front near the chassis, and
thread the connection cable of the display outwards
through the cable gland in the cover.
 Slide the flat-pin connector of the PE conductor into
place, and ensure that the cover and chassis are con-
nected.
 Place the cover fully over the chassis, and connect the
cover and the chassis using the four threaded bolts in
the corners of the cover.
Fig. 26: Cover on the chassis
Key
1 Threaded bolts (4x)
2 Outside of enclosure door
3Chassis
4Cover

Connect the display to the connector and insert the
entire infill panel on the cooling unit.
 Place the bottom louvred grille onto the holders and
secure the two stays at the top of the hinge mecha-
nism into the brackets attached to the cover of the
cooling unit.
 Finally, replace the top louvred grille onto the cover.
 If applicable, re-attach the door or side panel including
cooling unit to the enclosure, if not assembled directly
on the enclosure.
Warning!
The PE conductor which connects the
cover and the chassis must be connect-
ed to both connectors in all cases. Oth-
erwise, there is a risk of injury from
electric shock if the unit connection was
faulty or defective.