User manual

Rittal enclosure cooling unit 9
4 Transport and handling
EN
4 Transport and handling
4.1 Delivery
The cooling unit is supplied in one packaging unit.
 Check the packaging carefully for signs of damage.
Traces of oil on damaged packaging indicate a loss of
refrigerant and/or a leak in the cooling unit. Any pack-
aging damage may be the cause of a subsequent
functional failure.
4.2 Unpacking
 Remove the packaging materials from the cooling unit.
 Check the cooling unit for any damage that may have
occurred during transport.
 Check the supply contents for completeness (see sec-
tion 3.3 "Supply includes").
4.3 Transport
Depending on the chosen version, the cooling unit may
weigh up to 85 kg. The components in the cooling unit
chassis account for the bulk of the weight.
At the rear of the cooling unit is a handle which can be
used to briefly lift the cooling unit when inserting into the
mounting cut-out.
There is also an M12 thread at the top of the chassis,
into which a Rittal eyebolt (e.g. belonging to an enclo-
sure) may be screw-fastened. The cooling unit is readily
transported with the aid of lifting gear and an indoor
crane.
Fig. 3: Thread and eyebolt on top of the chassis
Key
1Eyebolt
2 M12 thread

Before transporting by crane, please ensure that the
lifting gear and crane have sufficient load capacity to
transport the cooling unit safely.
 Never allow anyone to stand beneath a suspended
load, even for a short time, during transportation by
crane.
 Protect the lifting gear on the crane hook from load de-
flection, because the load's centre of gravity may be
off-centre.
 First position the cooling unit close to the installation
site and protect from accidentally being knocked over.
Note:
After unpacking, the packaging materials
must be disposed of in an environmentally
friendly way.
Note:
Damage and other faults, e.g. incomplete de-
livery, should be reported immediately, in
writing, to the shipping company and to Rittal
GmbH & Co. KG.
Warning!
Please note the maximum weights that
may be lifted by individuals. It may be
necessary to use lifting gear.
Note:
An eyebolt with M12 thread may be ordered
as an accessory from Rittal (see section 13
"Accessories").