Installation instructions

8
DELIVERY CONTENTS
Figure A:
 Designation Number
1 Bread bin 1x
2 Bread bin lid 1x
3 Supporting pipe 1x
4 Fastening screw, preassembled 2x
5 Fastening screw, preassembled 4x
6 Lid carrier, preassembled 2x
7 Ventilation bezel 1x
8 Fastening angle 6x
9 Baseplate 12x
10 Side retaining bracket
(supporting pipe bearing)
2x
11 Lid supporting surface 1x
12 Fastening screw
– ASPA Pan Head 3.5 x 17
(without baseplates)
– ASPA Pan Head 3.5 x 25
(for one baseplate)
– ASPA Pan Head 3.5 x 30
(for two baseplates)
9x
9x
9x
13 Fastening screw 4x13 2x
14 Fastening screw 6x13.5 1x
15 Serrated lock washer 3x
- Drilling template 2x
PREPARATION
Remove all drawers that are located above
the drawer intended for the bread bin.
MOUNTING FASTENING ANGLE FOR
BREAD BIN
Figure B:
• Use a stop angle to mark out a right-hand
reference line in the base of the drawer at
a distance of 43 mm to the inside of the
carcass.
Figure C:
• Place the drill template, with the under-
side, onto the front of the drawer and
with the right-hand side up against the
reference line.
• Drill the holes with which the fastening
angle (8) is to be mounted.
• Determine the maximum case height.
If the height is in excess of 150 mm, the
fastening angle must be tted with a
baseplate (9), if it is higher than 158 mm,
two baseplates have to be used.
• Attach the two right-hand and the front
fastening angles, using two fastening
screws each (12).
• Attach the two left-hand and the rear
fastening angles, using one fastening
screw each (12) and a serrated lock
washer (15).
Do not tighten the screws yet so that the
position of the fastening angles can still
be adjusted.
• Mount the bread bin onto the fastening
angle:
– The "ritter" emblem should be visible at
the front.
– The bread bin should make contact with
the right and front fastening angles.
• Position the adjustable fastening angles
at the left and rear so that the bread bin
can be inserted and removed easily, but
with zero-clearance, if possible.
• Secure the position of the left-hand and
rear fastening angles.
INSTALLATION INSTRUCTIONS
English